Dynex DX-LCD32-09 User Manual (English) - Page 19

Maintaining 19 To delete the RRT information: 1 Press MENU. The on-screen menu opens. 2 Press or to select Lock, then press . The password entry screen opens. Picture Sound Enter Password Time Setup Lock - - - - Channel Select Move MENU Exit 3 Press the number buttons to enter the password. The default password is 0000. The Lock menu opens. Picture Sound Time Change Password System Lock US Canada RRT Setting Reset RRT Setup Lock Channel On Select Move MENU Exit 4 If necessary, press or to select System Lock, then press or to select On. 5 Press or to select Reset RRT, then press ENTER. 6 When a message asks if you want to clear the RRT Setting, select Yes to delete the RRT rating information, or select No to exit without deleting the information. Restoring factory defaults You can restore all settings to the factory defaults. When you restore settings, all customized settings are cleared, except the parental control password and the parental lock settings. After you restore settings, your TV needs to memorize channels again. To restore factory defaults: 1 Press MENU. The on-screen menu opens. 2 Press or to select Setup, then press to open the Setup menu. Picture Sound Time Setup Lock Channel Menu Language Transparency Zoom Mode Noise Reduction Advanced Closed Caption XVS Restore Default English Off Wide Weak Off Select Move MENU Exit 3 Press or to select Restore Default, then press or ENTER. 4 When a message asks if you want to restore factory settings, select Yes to restore the settings, or select No to exit without restoring settings. Maintaining To clean your TV: 1 Turn off and unplug your TV. 2 Wipe it with a soft, dry cloth. If the surfaces are extremely dirty, dampen a soft cloth with a soap and water solution or a weak detergent solution. Use eyeglass cleaner to remove stubborn dirt from the screen. Cautions: Never use alcohol, paint thinner, or benzine to clean your TV. Before using a chemically treated cloth, read the instructions that came with the cloth. Troubleshooting Caution: Never try to repair your TV yourself. Refer all servicing to qualified service personnel. Note: If the problem is not solved after you try the solutions in this section, turn off your TV, then turn it back on again. Remote control Problem Remote control does not work. Video and audio Solution • Make sure that the power cord is plugged into a power outlet. • Make sure that the batteries are installed correctly. Align the + and - symbols on the batteries with the + and - symbols in the battery compartment. • Replace the batteries. Problem Solution No picture (screen not lit) and no sound. • Make sure that the power cord is plugged into a power outlet. • Press on the remote control or the side of your TV. • Try another channel. Dark, poor, or no picture (screen lit) but good sound. • Adjust the brightness. • Select a different picture mode. • Make sure that the antenna or cable TV cables are connected securely. No color, incorrect color, or • Adjust the Color (color saturation) dark picture. on the Picture menu. Only snow and noise appear on the screen. • Try another channel. • Make sure that the antenna or cable TV cables are connected securely. Dotted lines or stripes. • Adjust the antenna. • Move your TV away from sources of interference such as cars, neon signs, or hair dryers. Double images. Good picture but no sound. Audio noise. • Adjust the antenna. You may need a high-directional outdoor antenna. • Press MUTE to make sure that the sound is not muted. • Make sure that the sound mode is set to Stereo or Mono. • Move devices that use IR (infrared) away from your TV.