Dynex DX-LCD32-09 User Manual (English) - Page 9

Using your TV 9 Connecting a digital optical audio device To connect a digital optical audio device: • Connect an optical audio cable to the S/PDIF jack on the back of your TV and to the S/PDIF In jack on the S/PDIF device. Optical audio cable Digital optical devices  S/PDIF IN jack Note: The S/PDIF jack on your TV sends audio for DTV channels only. Connecting headphones To connect headphones: • Connect the headphone cable to the (headphone) jack on the back of your TV. Warning: If the headphone volume is too loud, you may damage your hearing. Adjust the volume to a comfortable level. Using your TV Turning your TV on or off Note: The first time you turn on your TV, you need to select the TV signal source and your TV needs to memorize channels. For more information, see "Selecting the TV signal source" on page 9 and "Memorizing for channels" on page 10. To turn your TV on or off: 1 Plug the power cord into a power outlet. 2 Press on the remote control or the side of your TV. Your TV turns on. 3 Press again to put your TV in standby mode. Note: When your TV is in standby mode, power is still flowing into it. To completely disconnect power, unplug the power cord. Selecting the video input source To select the video input source: 1 Turn on your TV, then press INPUT. The INPUT SOURCE menu opens. 2 Press or to select an video input source, then press ENTER. You can select TV, AV, S-Video, Component1, Component2, HDMI1, HDMI2, or VGA. The remote control also has four direct video input buttons that you can press to go directly to the corresponding video input source. To use a direct video input button: • Press COMP once to select Component1 or twice to select Component2. • Press HDMI once to select HDMI1 or twice to select HDMI2. • Press VIDEO once to select AV or twice to select S-Video. • Press TV to select TV. Selecting the TV signal source To select the TV signal source: 1 Press MENU. The on-screen menu opens. 2 Press or to select Channel, then press Channel menu. to open the Picture Sound Air/Cable Auto Scan Favorite Show/Hide Channel No. Channel Label DTV Signal Time Setup Air Lock Channel 2-1 WGBH-SD : Good Select Move MENU Exit 3 Press or to select Air/Cable, then press or to select Air (for an antenna) or Cable (for cable or satellite TV). Using the on-screen menu Your TV has an on-screen menu that lets you adjust options and settings for your TV. Notes: Menu options that are grayed out are not available for the current video input source. To access the Lock menu, you must enter the password. The on-screen menus in this guide are for explanation purposes only. Some are cropped or enlarged and may vary slightly from the actual menus. The menus shown are for the DTV video input mode. The following illustrations show the main on-screen menus.