Dynex DX-LCD32-09 User Manual (English) - Page 20

20 Specifications General Problem Solution One or more channels cannot be displayed. Password lost. Some menu options cannot be accessed. TV cabinet creaks or makes noises. Control buttons on the TV do not work. • Make sure that your TV has memorized channels. • Make sure that the channel has not been deleted from the memorized channel list. If the channel was deleted, you can press the number buttons on the remote control to tune to the channel. • Make sure that the channel is not blocked through the parental controls. • If you have forgotten the password, enter 1397 to open the Lock menu and set a new password. • If an option is grayed, the option is not available for the current video input mode. • This is not a malfunction. When you use your TV, the temperature inside the cabinet increases. This causes the cabinet to expand or contract, which makes a creaking noise. • Unplug the power cord, wait a few seconds, plug the cord back in again, then turn on your TV. Specifications Product design and specifications are subject to change without notice. Type Panel TV system Receiving channels Audio multiplex Audio out Power requirement Power consumption Dimensions (W × H × D) Weight Temperature Input ports Output ports Control port LCD TV 32" TFT LCD NTSC-M, ATSC VHF: 2-13 UHF: 14-69 CATV: 1-125 CADTV: 1-135 DTV: 2-69 BTSC system 6W×2 AC 120 V, 60 Hz 150 W 31.9 × 23 × 10 inches (81.1 × 58.3 × 25.5 cm) 30.9 lbs (14 kg) Storage: 32° to 122°F (0° to 50°C) Working: 41° to 104°F (5° to 40°C) Composite video/audio (L/R) (1) S-Video (1) Component video/audio (L/R) (2) HDMI (2) VGA/audio (1) Antenna (1) Composite video/audio (L/R) (1) Headphone (1) S/PDIF (optical) (1) RS-232 Legal notices FCC Part 15 This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced technician for help. FCC warning Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user's authority to operate this equipment. FCC warning This is a CLASS B product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures to counter interference. Notices Specifications and features are subject to change without notice or obligation. For service and support call (800) 305-2204.