Dynex DX19L200A12 User Manual - Page 29

Changing channel settings DX-19L200A12 25 Automatically searching for channels To automatically search for channels: 1 Press MENU. The Main Menu screen appears. Main Menu Picture Audio CH Channel >> Lock Setup :Select ENTER :Set 2 Press or to select Channel, then press or ENTER. The Channel menu opens. 3 Press or to select Auto Ch Memory, then press or ENTER. The Auto Ch Memory screen opens. CH Auto Ch Memory Signal Type Automatic Search Cable Stop Analog Channel Found : 0 Digital Channel Found : 0 Programming Now :Select ENTER :Cancel 4 Press or to select Automatic Search, then press or ENTER. The TV begins memorizing all the channels available in your area. It may take from 15 minutes to 30 minutes to complete memorizing digital cable channels. Depending on the reception, a bar display may not advance for several minutes. Notes: • Memorizing channels is best accomplished during evening "PRIMETIME" hours, as more stations are broadcasting digital signals. Memorizing channels can only be accomplished while a station is broadcasting a digital signal to set that channel into memory. • If you are unsure of the digital channels available in your area, you may visit www.antennaweb.org to receive a list based on your address or zip code. • Should you require further assistance you may call the Dynex Customer Care Center 1-800-305-2204. • New digital channels may be added to your area periodically, it is recommended to perform the "Automatic Search" procedure regularly. Memorizing channels This TV is equipped with a channel memory feature which lets you skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the TV's memory. To use this TV with an antenna, set the Signal Type option to the Air mode. See "Setting the signal type" on page 24. When shipped from the factory, this menu option is in the Cable mode. Adding a new channel to memory If you find a new digital channel, you can add the new channel into the channel memory. To add channels to memory: 1 Tune to the new channel. 2 Press MENU. The Main Menu screen appears. Main Menu Picture Audio CH Channel >> Lock Setup :Select ENTER :Set 3 Press or to select Channel, then press or ENTER. The Channel menu opens. CH Channel Add/Delete >> DTV Signal >> Auto Ch Memory >> Ch Label >> :Select ENTER :Set