Edimax EW-7238RPD Quick Install Guide - Page 14
Press for two, seconds
View all Edimax EW-7238RPD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
2. Within two minutes, press and hold the WPS button on the extender for two seconds to activate WPS. The WPS LED ( ) will flash slowly to indicate WPS is activated (see LED Status). Press for two seconds 3. The devices will establish a connection. When a connection is successful, the extender's WPS LED ( ) will display on - and remain on for 5 minutes (see LED Status). 4. Please wait for 5 minutes until the extender's WPS LED ( ) is off, and repeat this process to set up your dual-band extender's additional second frequency band. In step 1 please activate WPS on your router/access point for the alternate frequency 2.4GHz or 5GHz depending on which frequency you previously set up. Note: Please check the instructions for your wireless router/access point to confirm how long you need to hold down its WPS button to activate WPS for 2.4GHz or 5GHz. Some brands of router/access point may not support WPS for 5Ghz - in this case, please use iQ Setup instead. 13