Electrolux EW26SS75QS Complete Owner's Guide (English) - Page 11

Removing the Doors 11 Installing Freezer Drawer 1 With lower slides pulled out, hang drawer onto slide brackets ensuring pins on each side are fully inserted into slots on each side. 6 Tighten four drawer screws. 7 Recheck gasket seal. 8 Install the toe grille by fitting into place. Assembly Fully Extend Drawer Slides Cabinet Pin Slot 2 Reinstall four drawer screws (two per side), tighten down, and close drawer. Install crews (2) each side 3 Check gasket seal around top, bottom, and sides of freezer drawer. 4 If gasket is not sealed, open drawer and slightly loosen four drawer screws (two on each side) to allow drawer to rotate. 5 Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer. Push Against Freezer Drawer A Grab Drawer at Center from Both Sides Then Pull Drawer Out B