Electrolux EW26SS75QS Complete Owner's Guide (English) - Page 14

14 Connecting the Water Supply another half turn with a wrench; DO NOT overtighten. See Figure 1. If you use stainless steel tubing - The nut and ferrule are already assembled on the tubing. Slide compression nut onto valve inlet and finger tighten compression nut onto valve. Tighten another half turn with a wrench; DO NOT overtighten. See Figure 2. 5. With steel clamp and screw, secure water supply line (copper tubing only) to rear panel of refrigerator as shown. 6. Coil excess water supply line (copper tubing only), about 2½ turns, behind refrigerator as shown and arrange coils so they do not vibrate or wear against any other surface. 7. Turn ON water supply at shutoff valve and tighten any connections that leak. 8. Reconnect refrigerator to electrical power source. 9. To turn ice maker on, lower wire signal arm (freezer ice maker) or set the ice maker's On/ Off power switch to the "ON" position (fresh food ice maker). Plastic Water Tubing Steel to Ice Maker Clamp Fill Tube Brass Compression Nut Ferrule (Sleeve) Copper water line Water Valve Bracket Valve Inlet Water Valve Copper water line from household water supply Plastic water tubing to ice maker fill tube Stainless steel water line Water valve bracket Valve inlet Water valve 6 ft. stainless steel water line from household water supply Figure 2 (Include enough tubing in loop to allow moving refrigerator out for cleaning) Figure 1