Electrolux EW26SS75QS Complete Owner's Guide (English) - Page 25

Changing the Water and Air Filters 25 Your refrigerator is equipped with separate water and air filtering systems. The water filter system filters all the water used to produce ice. The air filter removes odors and impurities from the refrigerator compartment. NOTE The control panel includes controls to monitor the status of your water and air filters. See the Controls section for more information. It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement. 1 Push the filter release button above the cartridge to disconnect it. Water Filter Button About your advanced water filter The PureAdvantageTM NGFC2000 filter system is tested and certified by NSF International to NSF/ANSI Standards 42 and 53 for the reduction of claims specified on the performance data sheet. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. • Rated Capacity - 240 gallons • Rated service flow - .5 gallons per minute • Maximum Rated Pressure - 100 pounds per square inch • Recommended Minimum Operating Pressure: 30 pounds per square inch • Operating Temp.: Min. 33°F, Max. 100°F Water filter The water filter is located at the lower left side of the fresh food compartment. Replacing your PureAdvantageTM water filter In general, you should change the water filter every six months to ensure the highest possible water quality. The Water Filter Status light on the Touch Panel prompts you to replace the filter after the six month time period has elasped. The water filter status light on this model is not performance tested or certified by NSF. If your refrigerator has not been used for a period of time (during moving for example), change the filter before reinstalling the refrigerator. Water Filter Cartridge Push Water Filter Button 2 Slide the old water filter cartridge straight out of the housing and discard it. 3 Unpack the new filter cartridge and remove the two protective caps covering the inlet and exit of the filter. Slide the filter gently into the housing until it stops against the snap-in connector at the back of the housing. Replacement Water Filter Remove Two Protective Caps