Epson ActionTower 3000 User Setup Information - Page 15

Caution, Turn off your computer

Get Epson ActionTower 3000 PDF manuals and user guides View all Epson ActionTower 3000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Note You can install C-type batteries in your speakers or obtain a DC 6-Volt input jack to power the speakers independently and use them as amplified speakers. This will boost the speaker's bass response and allow you to adjust the volume using the speaker's controls. If you do this, be sure to set the Amp switch on the back of each speaker to the On position and turn on the speakers before you turn on your system. Be sure to connect the speakers to the OUT connector on the sound card, as described below. Before you connect your speakers, locate the battery compartment on the back of each one. Inside the compartments are the cables you use to connect the speakers to the computer. Remove the cables. If necessary, attach one of the cable's wide connectors to the socket on the back of each speaker. If you are using your speakers as unamplified speakers, you must do the following before you connect them to your system: 0 Turn off your computer 0 If there is a power button on the front of each speaker, set it to the Off position 0 If there is an Amp switch on the back of each speaker, set it to the Off position to turn off the speaker's amplifier. Caution Do not connect mono speakers to the OUT connector; you could damage the speakers' amplifiers. 12 Read This First

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
Note
You can install C-type batteries in your speakers or obtain a
DC 6-Volt input jack to power the speakers independently
and use them as amplified speakers. This will boost the
speaker’s bass response and allow you to adjust the volume
using the speaker’s controls. If you do this, be sure to set the
Amp switch on the back of each speaker to the On position
and turn on the speakers before you turn on your system. Be
sure to connect the speakers to the OUT connector on the
sound card, as described below.
Before you connect your speakers, locate the battery
compartment on the back of each one. Inside the compartments
are the cables you use to connect the speakers to the computer.
Remove the cables. If necessary, attach one of the cable’s wide
connectors to the socket on the back of each speaker.
If you are using your speakers as unamplified speakers, you
must do the following before you connect them to your system:
0
Turn off your computer
0
If there is a power button on the front of each speaker, set it
to the Off position
0
If there is an Amp switch on the back of each speaker, set it
to the Off position to turn off the speaker’s amplifier.
Caution
Do not connect mono speakers to the OUT connector; you
could damage the speakers’ amplifiers.
12
Read This First