Epson C32C824151 Technical Reference - Page 19

2.5 UB-E02 Installation UB-E02 Technical Reference Guide CAUTION: Before installing the UB-E02, be sure to set the DIP switches or Memory switches as shown in the table below. For other models, please ask your dealer. Model TM-U200 Series TM-U210 Series TM-U230 Series TM-U325 Series TM-U590 Series TM-U675 Series TM-T88/T88II/T88III TM-T90 TM-H5000/H5000II TM-H6000/H6000II TM-J7000/J7100 TM-J7500/J7600 TM-J2000/J2100 TM-L90 Setting DIP SW 2-8: ON DIP SW 2-8: ON DIP SW 2-8: ON DIP SW 2-8: ON DIP SW 2-8: ON DIP SW 2-8: ON DIP SW 2-8: ON MSW 1-8: ON DIP SW 2-8: ON DIP SW 2-8: ON MSW 1-8: ON MSW 1-8: ON MSW 1-8: ON MSW 1-8: ON Be sure to disconnect the power supply of the printer (in addition to turning off the power switch) .Even when the power switch is turned off, some of the internal circuit board has electricity. If you install or remove the UB-E02 with the power supply connected, the UB-E02 and the printer may be damaged. 1. Be sure that the power for the printer and host computer is turned off. 2. Install the UB-E02 in the printer. If an interface circuit board is already installed, remove it and install the UB-E02. remove screw remove screw Rev. A Installation 2-3