Epson C32C824151 Technical Reference - Page 20
approximately 6 seconds
UPC - 000054074415
View all Epson C32C824151 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
3. Tighten the screws. If you have removed an interface circuit board that was already installed, fix the UB-E02 using the removed screws. 4. Plug the twist pair cable into the 10BASE-T/100BASE-TX Ethernet connector of the UB-E02 until it clicks. CAUTION: Be sure not to connect a telephone line, display module connector, or drawer kick-out connector cable to the 10BASE-T/100BASE-TX Ethernet connector of the UB-E02. The display module connector on the TM printer cannot be used when the UB-E02 is installed. 5. Connect the power unit to the printer. 6. Turn on the printer power. Note: When initializing the UB-E02 by turning off the power and then turning it back on or by resetting the printer, there is a waiting time until the network starts operating. During this time, all the communicating functions of the network do not work. The waiting time is: When the IP address setting is Manual (Fixed): approximately 6 seconds When the IP address setting is Auto: approximately 13 seconds (It can be longer, depending on the reply time of the host.) 2-4 Installation Rev. A