Epson C32C824151 Technical Reference - Page 23

UB-E02 Technical Reference Guide 2.8 FAQ 2.8.1 Q1. The printer does not operate correctly. ("Serial interface" is printed by the self test for the printer.) 2.8.1.1 A1. For TM-T90, TM-L90, TM-J2000, TM-J2100, TM-J7000, TM-J7100, TM-J7500, and TM-J7600, set the #25 pin reset signal of the Memory switch set to disabled. For other models, use the printer with the #31 pin reset signal of the DIP switch for parallel interface enabled. Model TM-U200 Series TM-U210 Series TM-U230 Series TM-U325 Series TM-U590 Series TM-U675 Series TM-T88/T88II/T88III TM-T90 TM-H5000/H5000II TM-H6000/H6000II TM-J7000/J7100 TM-J7500/J7600 TM-J2000/J2100 TM-L90 Setting DIP SW 2-8: ON DIP SW 2-8: ON DIP SW 2-8: ON DIP SW 2-8: ON DIP SW 2-8: ON DIP SW 2-8: ON DIP SW 2-8: ON MSW 1-8: ON DIP SW 2-8: ON DIP SW 2-8: ON MSW 1-8: ON MSW 1-8: ON MSW 1-8: ON MSW 1-8: ON 2.8.2 Q2. The self test does not operate correctly. 2.8.2.1 A2. Turn on the printer power while pressing the FEED button and hold the Feed button until printing starts to perform the self test for the printer with the UB-E02. Printing starts in approximately 6 seconds when the IP address is fixed or approximately 13 seconds when the IP address is acquired by auto setting. (It can be longer, depending on the reply time of the host.) 2.8.3 Q3. Starting up the printer takes a long time. 2.8.3.1 A3. When the auto setting is set for IP address acquisition without a DHCP server, starting up the printer takes about one minute. During this time, the self test for the printer is not performed. Set the manual setting for IP address acquisition where the DHCP server is not available. Rev. A Installation 2-7