Epson DM-D500 Installation Guide - Page 24

English Connectors for the DM-D stand The connectors for the DM-D stand are shown in illustration 55. computer connector display connector printer connector 55 power supply unit connector extension cable connector Note: The DM-D stand comes with inch-type hexagonal lock screws installed to secure the interface cable to the interface connector for the RS-232. If you plan to use an interface cable that requires millimeter-type lock screws, replace the inch-type screws with the included millimeter-type screws using a hex screwdriver (5 mm {0.2"}). To distinguish the two types of screws, see illustration 56. notch (one or more lines) 56 inch-type millimeter-type Jumper settings Set the jumpers on the DM-D stand as follows: RS-232 connector installation screw JP1 JP2 Contents 1-2 1-2 When connecting both the TM printer and the DM-D stand. (Default setting.) 2-3 2-3 When using the DM-D stand as a standalone. (TM printer is not connected.) The jumpers are located as shown in illustration 57. 57 22 DM-D500 Installation Guide