Epson DM-D500 Installation Guide - Page 31

English DIP switch 2 DSW2 No. 2-1 2-2 2-3 2-4 2-5 2-6 2-7 2-8 Function Y-connection (*1) Self test selection (*2) 20 column and 2 line mode selection (*3) Device selection default setting Address 0 Address 1 Address 2 Reserved (*5) ON OFF Enabled Perform self test 20 column and 2 line mode Printer is selected Disabled Do not perform 256 × 64 dots mode Display is selected Default setting OFF OFF OFF OFF The display device number (1-7) corresponds to OFF Address number 0 to 2. (All OFF is regarded as OFF no display number.) OFF − Fixed to OFF OFF (*1) The "Y-connection enable" is set when a TM printer with no modular jack for the DM-D is connected with this product, using one COM port to connect both TM printer and DM display. In this case, an optional DM-D stand (DP-501) and a connecting cable are required. In cases other than above, choose "Y-connection disabled" (default setting). (*2) This function can select whether or not you perform self test when turning on the power. See "Self Test" for details. (*3) When selecting "20 column and 2 line mode," this product can be used like the DM-D105/106/205/206. In this case, the graphic display and the original functions for the DM-D500 cannot be used; however, by selecting "256 × 64 dots mode," they can be used. (*4) When setting to "Printer is selected," data is sent to the TM printer, but is not displayed on the display. When setting to "Display is selected," data is displayed on the display but is not output from the TM printer. The selection can be changed using the command. (*5) Stays at OFF setting. Note: ❏ The changes in DIP switch settings are effective when the power is turned on again. ❏ The data transmission setting, such as data length and transmission speed, must be the same on both your computer and printer. DM-D500 Installation Guide 29