Epson LQ-300 Product Information Guide - Page 5

,* .-. l Incerteinareas,Ulefdlowing~ertaM~,are~e: Pc437, Pc050, Pc864, Pu37GLeek, Pc8s2,Pctl53, Pcass, Pc857, PO866, PC869, IS0 Latin IT, IS0 88597, code MJK, MAZOWIA, Bulgaria Note: Because @ware settings always ommide the printer0 dejblt settings, use your sojbare program to control the printer, if possible. See your @ware documentatim~ more ittformafion. Character table Character tables contain the characters and symbols used in different languages. Your printer includes a wide variety of character tables. Page length This option is available only when you use continuous paper with the tractor. You can set the page length to 8.5, 11,12, or 70/6(the length of A4 paper) inches. Skip-over-perforation When you turn on this feature, the printer skips over the perforations of continuous paper, providing a l-inch marginbehyeenthelastiineprintedono~pageandthe first line printed on the next. Because most software programs set their own top and bottom margins, you should use this feature only if your program does not provide them. This feature does not affect single-sheet paper* Auto tear off When you use continuous paper with the push tractor, this feature advances the paper perforation to the tear-off position where you can easily tear off the printed pages. When the printer receives data, it automatically reverses the paper to the top-of-form position and starts prinsoyoucanuseallofthenextsheet.Whenyouusethe tractor to print on labels, set this feature to off. *--. EPSON LQ-300 Graphic print direction You can choose unidirectional or bidirectional as the print direction for graphics. The printer usually prints text and graphics bidirectionally for fast printing. To print graphics unidirectionally for precise vertical alignment of print dots select unidirectional printing. software You can select the kind of printer commands used by your printer. When you select ESC/P 2," the printer emulates an EPSON ESC/P 2 printer. When you select IBM@ X24E, the printer operates as an IBM Proprinter" X24E. If possible, choose an EFSON ESC/P 2 printer in your software programs. This will allow you to use the most advanced font and graphics handling available. (Emulation means that the printer can understand and respond to commands as if it were an X24E.) AGM (Alternate Graphics Mode) When AGM is set to On, the printer can use high-resolution 24pi.n graphics commands. The default setting is off. When you select IBM X24E, this setting is available. Auto line feed When the auto line feed feature is on, each carriage return (CR) code is accompanied by a line feed (LF) code. If your printed text is unexpectedly double-spaced, set this feature to Off. If text lines print on top of each other, set it toon. Interface When this feature is set to Auto, the printer determines which interface is receiving data and switches to that interface until the end of the print job (when no data is received from the selected interface for the amount of time specified), You can specify either 10 seconds or 30 seconds. Set this option to Parallel only if you want the printer to ignore data from the serial interface or to Serial only if you want the printer to ignore data from the parallel interface. Bit rate, parity bit, data length, and ETX/ACK These options are available only when the interface is set to Serial. See your computer manual for the appropriate settings. State reply For normal operation leave this option set to Off (default). Dot Matrix Printers 10/2/94 EPSON LQ-300-5