Epson SureColor T5270D User Manual - Page 171

Epson SureColor T-Series User's Guide Problem Solver Messages Paper Length Error Insufficient remaining amount in specified roll paper. Continue to print with paper currently loaded? Roll Switch Error Cannot switch roll paper automatically. Check printer settings. Continue to print with paper currently loaded? Firmware Error Firmware mismatch between PS3 Expansion Unit and printer. Refer to manual for details. Information Cannot start copy because non-supported media is loaded. Refer to manual for details. Information Cannot send file. Refer to manual for details. Information Cannot receive mail. Refer to manual for details. What to do The remaining amount of roll paper loaded in Roll 1 and Roll 2 is shorter than the print length, so the roll paper cannot be switched. If the Z button is pressed, the printer prints to the roll paper currently in use. If the ( button is pressed, paper can be replaced. If you want to print even though remaining amount of roll paper is shorter than the print length, open the Setup menu, and then under Roll Switch Condition, change Paper Length to a setting other than Print Length. U"Setup menu" on page 139 If one of the following settings in the Setup menu is set as follows, roll paper is not switched automatically. O Auto Cut is Off. O Auto Loading is Off. If the Z button is pressed, the printer prints to the roll paper currently in use. If the ( button is pressed, paper can be replaced. To enable automatic switching of roll paper, change both settings above to On. U"Setup menu" on page 139 Operation is not possible because the versions of firmware of the optional Adobe PostScript 3 Expansion Unit and the firmware of the printer are not compatible. Update both to the latest firmware. The latest firmware can be downloaded from the Epson website. Load paper that supports large copy/large scan, and then print the copy/scan file again. For paper that supports large copy/large scan, see the following. U"Epson Special Media Table" on page 187 If you tried to copy or send a large-scan image file to a shared folder, and this message appears, check the following. O Are the folder path, username, and password configured correctly in the shared folder address setting of CopyCenter? O Is there already a file with the same name in the save/transfer destination folder? O Is there sufficient empty space in the save/destination folder? If you tried to send an e-mail, and this message appears, ask your network administrator if the e-mail settings have been configured correctly. Ask your network administrator if the e-mail settings have been configured correctly. 171