Epson TM-L500A Technical Reference Guide: RFID - Page 38
For Serial Interface, Transmission Speed DIP Switches 3/4
![]() |
View all Epson TM-L500A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
For Serial Interface SW Function 1 Reserved (Do not change) 2 Reserved (Do not change) 3 Transmission speed selections 4 5 DSR (hardware) reset 6 Reserved (Do not change) 7 Reserved (Do not change) 8 Reserved (Do not change) Initial ON OFF setting Fixed to ON ON Fixed to OFF OFF See the " Transmission Speed (DIP Switches 3/ ON 4)" table below. ON Enabled Disabled OFF Fixed to OFF OFF Fixed to OFF OFF Fixed to OFF OFF Transmission Speed (DIP Switches 3/4) Transmission speed (bps) Setting with the memory switch*: 2400, 4800, 9600, 19200 (initial setting), 38400, 57600, 115200 9600 19200 38400 SW 3 ON OFF ON OFF SW 4 ON ON OFF OFF bps: bits per second * When DIP switches 3 and 4 are set to ON, the value (initially 19200) can be set to any of the values listed in the lower portion of the row using a command, memory switch setting mode, or the TM-L500A Utility. (See "Setting the Memory Switches" on page 45.) Depending on print conditions, such as print duty, print head temperature, and data transmission speed, print speed is automatically adjusted, which can cause white lines due to intermittent print (the motor sometimes stops). To avoid this, set the transmission speed higher or keep the print speed constant by setting it lower. (See "Setting the Memory Switches" on page 45.) 38
![](/manual_guide/products/epson-tml500a-technical-reference-guide-rfid-9f507f7/38.png)