Epson TM-m30II Technical Reference Guide TM-m30II-H - Page 69
Auto re-connect to iOS device, model, Security Settings, the roll paper cover.
View all Epson TM-m30II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Chapter 3 Advanced Usage Auto re-connect to iOS device (Bluetooth model) In Bluetooth model, select [Bluetooth Setup] and then select [Auto Re-Connect iOS], you can select whether to enable or disable auto reconnection to iOS devices. • For details on the auto re-connect function, see "Auto Reconnect Feature" on page 111. • You can change the settings with TM-m30II Utility and TM Utility for iOS. Bluetooth Security Settings (Bluetooth model) For Bluetooth models, select [Bluetooth Setup], and then select [Security], and you can change the Bluetooth security settings. When the security settings are changed from "Middle" or "Low" to "High", or vice versa, the link key (pairing information) is deleted. If the printer is already paired with a terminal, unpair them and then pair again. You can change the settings with TM-m30II Utility and TM Utility for iOS/Android. Security Low Middle (initial setting) High Pairing Mode Pairing Method Pairing is always possible Just Works Pairing is possible for one minute after turning the printer on Just Works or after printing the status sheet Pairing is possible for one minute after printing the status Numeric Comparison/Passkey Entry sheet Pairing method when the security is set to Middle/High (from the printer) When the security is set to Middle/High and the printer is ready to be paired, perform the following procedure. 1 Load paper in the printer, and then turn it on. • Make sure no errors have occurred and that the printer is not off-line. • You cannot pair the printer while the network is starting up immediately after the power is turned on. 2 Open the roll paper cover, hold down the FEED button (two seconds), and then close the roll paper cover. 3 A status sheet is printed, and the Bluetooth LED flashes a pattern indicating that pairing is now possible. • Pairing is possible for one minute after printing the status sheet. • You can enable pairing also by printing the status sheet by pressing the status sheet button. 69