Epson U925 User Manual - Page 24
Changing the DIP switch settings, If you need to change settings, follow the steps below to make your
View all Epson U925 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Set 2 SW Function ON OFF Factory settings 2-1 Auto line feed Always enabled Always disabled OFF 2-2 Receive buffer 32 bytes 2048 bytes OFF 2-3 Font selection (default) 9 x 9 7 x 9 OFF Carriage speed 2-4 (default for paper Low roll printing) High OFF 2-5 Handshaking (BUSY condition) Receive buffer-full Off-line or receive buffer-full OFF 2-6 Internal use Fixed - ON 2-7 I/F pin 6 reset signal Enabled Disabled OFF 2-8 I/F pin 25 reset signal Enabled Disabled OFF Notes: 1. When pin 6 of the interface connector is used for the reset signal, the printer is reset at MARK on the RS-232C level. 2. When pin 25 of the interface connector is used for the reset signal, the printer is reset at SPACE on the RS-232C level or at HIGH on the TTL level. 3. DIP switches excluding switch 2-1 (Auto line feed) and switches 2-7 and 2-8 (interface reset signal) are effective only while the printer power is turned on. If the DIP switch setting is changed after the printer power is turned on, the change is not effective. 4. If DIP switch 2-7 or 2-8 is on while the printer power is turned on, the printer may be reset, depending on the signal state. DIP switches should not be operated while the printer power is turned on. Changing the DIP switch settings If you need to change settings, follow the steps below to make your changes: 1-14 Setting Up the Printer