Epson U925 User Manual - Page 26

Adjusting the Paper Near End Detector, ESC c 4

Get Epson U925 - TM B/W Dot-matrix Printer PDF manuals and user guides View all Epson U925 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

4. Replace the DIP switch cover by inserting it upward and sliding it to the left as shown below. Then secure it with the screw. DSW DSW2 1 2 5. The new settings take effect when you turn on the printer. Adjusting the Paper Near End Detector The paper near end detector detects when the paper is almost gone by measuring the diameter of the paper roll. Software programs can use the ESC c 4 command to stop printing when the paper is almost gone. If you want to change the amount of paper remaining when the printer stops printing, follow the steps below to adjust the paper near end detector. Note: The printer also has a paper end-sensor that stops the printer at the very end of a roll. This sensor cannot be turned off by software. 1. Open the printer cover and remove the paper roll. 1-16 Setting Up the Printer

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
1-16
Setting Up the Printer
4.
Replace the DIP switch cover by inserting it upward and
sliding it to the left as shown below. Then secure it with the
screw.
5.
The new settings take effect when you turn on the printer.
Adjusting the Paper Near End Detector
The paper near end detector detects when the paper is almost gone
by measuring the diameter of the paper roll. Software programs
can use the
ESC c 4
command to stop printing when the paper is
almost gone.
If you want to change the amount of paper remaining when the
printer stops printing, follow the steps below to adjust the paper
near end detector.
Note:
The printer also has a paper end-sensor that stops the printer at the
very end of a roll. This sensor cannot be turned off by software.
1.
Open the printer cover and remove the paper roll.
DSW
DSW2
1
2