Fisher and Paykel DD24DCTX7 BOOK INSTL DD24D Ph7 US CA EN (English) - Page 21

25 FINAL CHECKLIST 26 TROUBLESHOOTING 21 Check all parts are installed. Ensure product is level, securely fastened to the cabinetry and opens and closes freely. The drawers must be free to fully close with no resistance from the cabinetry. Ensure inlet hose to water supply has supplied rubber washer fitted, and that it's tightened a further half turn after seal contact. Ensure any knockouts or plugs in drain connection have been drilled out and drain connection has been made. The drain hose joiner must not support the weight of excess hose material. Keep drain hose as fully extended as possible to prevent sagging. Any excess length of drain hose should be kept on the dishwasher side of the highloop. If connecting the drain hose to the sink trap, ensure the Highloop is a minimum 6" (150 mm) higher than the drain hose joiner. Ensure any packaging or tape securing the racks is removed from the drawers. Turn on the power and water supplies, then open the drawers. You should hear a beep and see a program indicator light up on the internal control panel. Check the spray arms are in place and free to rotate. Spray arm Add three cups of water into each drawer. Press on the internal control panel until the indicator of the 'Rinse' program lights up. Close the drawers and press to start the program. After the Rinse program has finished, ensure the dishwasher has run and drained correctly. Check water supply and drainage connection for leakage. Excessive water remaining above the filter plate, after the rinse cycle Check for a kinked drain hose or blocked waste connection, highloop not properly installed or drain hose not routed correctly. No water supply (This is displayed as a 'U1' fault -- see section 'If there is a fault' in the User guide for how to recognise this fault on models without a display.) Check water is connected and turned on. The dishwasher is beeping continuously There is a fault. See section 'If there is a fault' in the User guide for further information and instructions. No program indicator lights up when the drawer is opened Ensure power is connected and is switched on. If it is and still no indicator lights up, see the 'Preference options' section of the 'Quick start guide'. An option called 'Open drawer auto power-on' may need to be turned on. Water around water supply and drainage connections Check connections, existing plumbing and hoses for leaks. Check rubber washer and hose clamp are correctly fitted. If product is tipping Ensure the product is secured to the cabinetry. If front panels are misaligned Check and relevel product. Check the cabinetry is square. For Integrated models, check and adjust front panel alignment if necessary. Drawer doesn't close properly Ensure nothing is obstructing the drawer from closing properly eg sound insulation, hoses or drawer latches. If a problem occurs, consult the 'Troubleshooting' section of the User guide. If after checking these points you still need assistance, please refer to the Service & Warranty book for warranty details and your nearest Authorized Service Center, or contact us through our website, listed below. Important! SAVE THESE INSTRUCTIONS The models shown in this document may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our local website listed at the end of this document or contact your local Fisher & Paykel dealer. www.fisherpaykel.com www.fisherpaykel.ca