Fisher and Paykel DD24DCTX7 BOOK INSTL DD24D Ph7 US CA EN (English) - Page 5

Optionally Hard Wiring Prior To Installation

Get Fisher and Paykel DD24DCTX7 PDF manuals and user guides View all Fisher and Paykel DD24DCTX7 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

4 OPTIONALLY HARD WIRING PRIOR TO INSTALLATION 5 4a REMOVE THE LOWER DRAWER 43 4b REMOVE THE ACCESS COVER & POWER CORD 4 1 2 41"0(100m0mmm) Access cover To prevent kinked hoses, we recommend rotating the drawer anti-clockwise and resting 5it on its side after removal. Press the release tabs in on either side and push back to release drawer from runners. 4c TERMINATE THE WIRING AS SHOWN Remove knock-out for cable clamp and fit a suitable cable clamp for the conduit. 5 6 8 7 WARNING! Electrical Shock Hazard Before continuing, ensure that the product is disconnected from the power supply. Failure to follow this warning may result in electrical shock, injury or fire. 87 4d REFIT THE DRAWER ONTO THE RUNNERS & CLOSE Ensure the drawer Pounllbfootrhwsairddesth4e"(r1e0le0amsemt)abs is now rotated clockwise back. 16 15 11 11 10 9 12 Use copper conductors only. 19 13 Ensure the release tabs on both sides are reset fully. Before refitting the drawer, ensure the hoses are not twisted and the latches at the rear of each drawer runner are facing forward. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
5
OPTIONALLY HARD WIRING PRIOR TO INSTALLATION
9
12
11
11
10
4
5
6
7
7
8
8
4a
4c
4
4b
REMOVE THE LOWER DRAWER
TERMINATE THE WIRING AS SHOWN
REMOVE THE ACCESS COVER & POWER CORD
100 mm
2
4
5
1
4” (100mm)
To prevent kinked hoses, we recommend
rotating the drawer anti-clockwise and
resting it on its side after removal.
Access
cover
Press the release tabs in on
either side and push back
to release drawer from
runners.
3
Remove knock-out for cable clamp and
fit a suitable cable clamp for the conduit.
Use copper conductors only.
4d
REFIT THE DRAWER ONTO THE RUNNERS & CLOSE
13
14
15
16
19
Before refitting the drawer,
ensure the hoses are not
twisted and the latches at
the rear of each drawer
runner are facing forward.
Ensure the release tabs on
both sides are reset fully.
Ensure the drawer
is now rotated
clockwise back.
Pull forward the release tabs
on both sides 4”(100
mm)
Electrical Shock Hazard
Before continuing, ensure that the product is
disconnected from the power supply.
Failure to follow this warning may result in
electrical shock, injury or fire.
WARNING!