Fujitsu MBA3147RC Product Manual - Page 53
Power Supply Requirements, Current waveform, Max seek
![]() |
UPC - 102646074718
View all Fujitsu MBA3147RC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
4.2 Power Supply Requirements Figure 4.7 shows the Max Seek current waveform of+5V DC and +12V DC. Time (2 sec/div) Time (2 sec/div) Time (2 sec/div) Time (2 sec/div) Time (2 sec/div) Time (2 sec/div) Figure 4.7 Current waveform (Max seek) (3) Power on/off sequence The order of the power on/off sequence of +5V DC and +12V DC, supplied to the HDDs, does not matter. (4) Sequential starting of spindle motors After power is turned on to the HDDs, a large amount of current flows in the +12V DC line when the spindle motor rotation starts. Therefore, if more than one HDD is used, the spindle motors should be started sequentially using one of the following procedures to prevent overload of the power supply unit. a) Control the sending of the NOTIFY (ENABLE SPINUP) primitive so that the spindle motors of individual HDD are started in intervals of 12 seconds or more. b) Turn on the +12V DC power in the power supply unit at intervals of 12 seconds or more to start the spindle motors sequentially. C141-E252 49
![](/manual_guide/products/fujitsu-mba3147rc-product-manual-93fa144/53.png)