Fujitsu MBA3147RC Product Manual - Page 63
Formatting
UPC - 102646074718
View all Fujitsu MBA3147RC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
5.4 Checking Operation after Installation and Preparing the HDDs for Use c) Issue the REQUEST SENSE command to collect sense data. When sense data has been collected successfully, perform an analysis to check for recoverable errors, and retry operations for recovery from any such errors. (5) Checking at abnormal end When sense data can be obtained, analyze the sense data and retry recovery for a recoverable error. Refer to Chapter 6 "Sense Data and Error Recovery Method" of the SAS INTERFACE MANUAL for further details. 5.4.2 Formatting Since the HDD is formatted with a specific (default) data format for each model (part number) when shipped from the factory, the disk need not be formatted (initialized) when it is installed in the system. However, when the system needs data attributes different from the default format, all sides of the disk must be formatted (initialized) according to the procedures below. The user can change the following data attributes at initialization: • Logical data block length • Number of logical data blocks in the user space This section outlines the formatting at installation. Refer to Subsection 4.1.4 "MODE SELECT (15)", 4.1.5 "MODE SELECT EXTENDED (55)", 4.3.1 "FORMAT UNIT (04)", and Chapter 7 "Disk Media Management" of the SAS INTERFACE MANUAL for further details. (1) MODE SELECT/MODE SELECT EXTENDED command Specify the format attributes on the disk with the MODE SELECT or MODE SELECT EXTENDED command. The parameters are as follows. a. Block descriptor Specify the size (byte length) of the logical data block in the "data block length" field. To explicitly specify the number of logical data blocks, specify the number in the "number of data blocks" field. Otherwise, specify 0 in "number of data blocks" field. In this case, the currently set value is used. b. Format parameter (page code = 3) Specify the number of spare sectors for each cell in the "alternate sectors/zone" field (cannot be changed). C141-E252 59