Fujitsu MHN2100AT Manual/User Guide - Page 220
completion of command, a previously existed cache data before the full hit
View all Fujitsu MHN2100AT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 220 highlights
Operations 4) Finally, the cache data in the buffer is as follows. Read-ahead data Start LBA Last LBA c. Non-sequential command immediately after sequential command When a sequential read command (first read) has been executed, the first read operation should be stopped if a non-sequential read command has been received and then, ten or more of the non-sequential read commands have been received. (Refer to 6.5.3.1.) The figure that describes the first read operation is the same as that shown in the sub-section a. 6.4.3.3 Full hit (hit all) All requested data are stored in the data buffer. The disk drive starts transferring the requested data from the address of which the requested data is stored. After completion of command, a previously existed cache data before the full hit reading are still kept in the buffer, and the disk drive does not perform the readahead operation. 1) In the case that the contents of the data buffer is as follows for example and the previous command is a sequential read command, the disk drive sets the HAP to the address of which the hit data is stored. Last position at previous read command HAP HAP (set to hit position for data transfer) Cache data Full hit data Cache data Last position at previous read command DAP 0 2) The disk drive transfers the requested data but does not perform the readahead operation. Cache data Full hit data HAP (stopped) Cache data 6-18 C141-E120-02EN