Garmin GPSMAP 5212 Installation Instructions - Page 2
Flush Mounting the GPSMAP 4000/5000 Series Chartplotter
UPC - 753759066109
View all Garmin GPSMAP 5212 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
To install the bail-mount bracket ➊: Note: You cannot bail mount the GPSMAP 5015/5215 chartplotters. Because of the larger size, you must flush mount the GPSMAP 5015/5215 chartplotter. 1. Using the bail mount as a template, mark the location of the four mounting holes. Be sure to leave at least 5 in. (12.7 cm) of clearance behind the 4000/5000 series chartplotter for the wiring. NOTE: Mount a GPSMAP 4008/4208/5008/5208 chartplotter 31 1/2 in. (80 cm), and a GPSMAP 4010/4210/4012/4212/5012/5212 chartplotter 39 3/8 in. (1 m) from a magnetic compass to avoid interference. 2. Using an appropriately sized drill bit, drill the pilot holes for your mounting hardware. 3. Secure the bail mount to the surface with your mounting hardware. To install the GPSMAP 4000/5000 series chartplotter on the bail-mount bracket ➋: 1. Loosely attach the mounting knobs to the GPSMAP 4000/5000 series chartplotter. 2. Slide the chartplotter onto the bail mount, and tighten the mounting knobs. Mounting knobs ×2 ➋ ➊ Flush Mounting the GPSMAP 4000/5000 Series Chartplotter The flush-mount method you will use with your chartplotter is dependent on the model. Be sure to follow the instructions for your chartplotter model. Flush Mounting a GPSMAP 4008/4208/4012/4212 Chartplotter or a GPSMAP 5008/5208/5012/5212 Chartplotter Hardware (included): • Flush-mount template Tools required (not included): • Jigsaw • Rubber gasket • Masking tape • Four threaded 4 mm mounting studs • Scissors • Four 4-mm flat washers • Drill • Four 4-mm lock washers • Drill bits-3/8 in. (10 mm) and 4 mm • Four 4-mm nuts • 1/16 in. (2 mm) Allen (Hex) wrench • 4 mm socket or wrench • Center punch and hammer GPSMAP 4000/5000 Series Installation Instructions