Genie PowerLift Excelerator Owner's Manual - Page 11

NOTE • Loosen (Do Not Remove) Terminal Block Screws. • Limit Switch adjustments and securing the Wires will be done later. F Lay Wires in channel on top of Rail and secure with Wire Clips (Figure 14). G Coil and bundle excess Limit Switch Wires on top of Power Head with Twist Ties. Leave just enough Wire to reach Terminals on back of Power Head (Figure 14). H Turn Opener upside down, and connect Limit Switch Wires to Power Head Terminal Block (Figure 15): • Terminal 4: OPEN Limit Switch Wire (white). • Terminal 5: OPEN Limit Switch Wire (white) and CLOSE Limit Switch Wire (brown). • Terminal 6: CLOSE Limit Switch Wire (brown). A ss e m bly St epCh7: Attach Emergency Release Cord and Knob • Tie overhand knot at one end of emergency release cord and pull cord through the hole in the release lever up to the knot (Figure 16). • Thread opposite end of cord through knob and tie a knot in this end also. • Following installation of your garage door opener, adjust the height of the knob to no less than 6 feet above the floor. * The Emergency Release Cord is threaded through the Carriage release lever at the factory. Antenna Terminal Block White Limit Brown Limit Switch wires Switch wires Figure 15 Connect Limit Switch Wires to Power Head Terminal Block A s se m b ly Step C8h: Record Opener Model and Serial Number Please note the following information so it is available if you need to call us: Date purchased: Serial number (Figure 17): Remote Control Model: Model number (Figure 17): Dealer Name: Dealer Address: City: State: Zip: Phone: NOTE Please keep original or photocopy of your sales receipt with this manual for future reference should service ever be required. For Help, call 1-800-35-GENIE or visit www.geniecompany.com Figure 16 Attach Emergency Release Cord and Knob Serial Number (example) Model Number Figure 17 Model and Serial Numbers 11