Genie PowerLift Excelerator Owner's Manual - Page 15
Installation Step 5
View all Genie PowerLift Excelerator manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
In sta lla tio n SteCph5: Assemble and Door Arms Connect OPEN YELLOW PARTS BAG For sectional doors: A Attach Curved Door Arm to Door Bracket with Clevis Pin and Cotter Pin (Figure 23A). B Attach Straight Door Arm to Magnetic Carriage Assembly. C Attach both Arms together with 2 (3/8" x 7/8") Hex Head Bolts and 2 (3/8") Serrated Flange Hex Nuts so overall length is as short as possible. Securely tighten fasteners. D Adjust height of Emergency Release Cord Knob to 6' above floor: • • Pull Cord through Magnetic Carriage Assembly Lever until Knob is 6' from floor. Tie a new overhand knot in Cord at Magnetic Carriage Assembly Lever. For one-piece doors: A Attach Straight Arm to Door Bracket with Clevis Pin and Cotter Pin (Figure 23B). B Attach Curved Arm to Magnetic Carriage Assembly. C Attach both Arms together with 2 (3/8" x 7/8") Hex Head Bolts and 2 (3/8") Serrated Flange Hex Nuts so overall length is as long as possible. Securely tighten fasteners. D Adjust height of Emergency Release Cord Knob to 6' above floor: • • Pull Cord through Magnetic Carriage Assembly Lever until Knob is 6' from floor. Tie a new overhand knot in Cord at Magnetic Carriage Assembly Lever. WARNING Do Not skip Step D above! Failure to comply may leave Emergency Release Knob within reach of children. If the Knob is pulled with garage door fully or partially open, garage door may close without warning! Clevis Pins Cotter Pins Safe-T-Beam® (STB) Brackets 3/8" x 7/8" Hex Head Bolts #10-16 x 11/4" Phillips Hex Head Screw 3/8" Hex Serrated Flange Nuts Hardware (yellow bag) As short as possible Straight Door Arm Curved Door Arm Figure 23A Assemble Arms (SECTIONAL) As long as possible For Help, call 1-800-35-GENIE or visit www.geniecompany.com Straight Door Arm Curved Door Arm Figure 23B Assemble Arms (ONE-PIECE) 15