Genie PowerLift Excelerator Owner's Manual - Page 19

In sta lla tion SteCph8: Connecting Power ELECTRICAL WARNING • To reduce the risk of electrical shock, this equipment has a grounding type Plug that has a third (grounding) Pin. This Plug will only fit into a grounding type outlet. If the Plug does not fit into the outlet, contact a qualified electrician to install the proper outlet. Do Not change the Plug in any way. The door Opener must be properly grounded to prevent personal injury and damage to the components. • The electrical power to the door Opener Must Be removed when the Motor Cover is removed. Electrical power must remain off while making electrical connections. A Check building codes: • • If building code requires Opener be permanently wired to building, have a licensed electrician perform step B. If you are not installing permanent wiring, go to step C. B Instructions for licensed electrician - connecting power with permanent wiring (Figure 32): • Remove power from circuit. • Remove Motor Cover. • Remove and discard Power Cord. - Cut off Power Cord inside Power Head as near Strain Relief as possible. - Remove Knock-Out Plug, Strain Relief, and Power Two Cord. (Cut Ground Wire on line side of Toroid). - Dispose of Plug, Strain Relief, and Power Cord. tabs slide out • Install required entrance bushing. • Connect permanent wiring to Power Head Wires. - White supply line to Opener White Wire. - Black supply line to Opener Black Wire. - Ground to Opener Green Wire. - Replace Motor Cover. Knockout Cut Wires here NOTE • Use only Underwriters Laboratories, Inc. (U.L.) recognized wire nuts. • The Circuit Boards are light sensitive. Ensure the Motor Cover is installed before energizing the Opener. Four screws hold Motor Cover Figure 32 Connecting power with permanent wiring - Restore Power to circuit. C Connecting Power with Plug: • Plug Opener into a grounded outlet as stated in previous electrical warning. D Perform Safe-T-Beam® alignment check: • Check if Safe-T-Beam® Source Red LED is glowing continuously (OK) or blinking (problem). • If Red LED is blinking twice, adjust Sensor Brackets as needed to make Red LED glow continuously. (Refer to page 26.) For Help, call 1-800-35-GENIE or visit www.geniecompany.com 19