Gigabyte G1.Assassin Manual - Page 30
GSATA3_6/7 SATA 6Gb/s Connectors, Controlled by Marvell 88SE9182, SATA2_0/1/2/3/4/5 SATA 3Gb/s
UPC - 818313012203
View all Gigabyte G1.Assassin manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
7) SATA2_0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by Intel ICH10R) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel ICH10R controller supports RAID 0, RAID 1, RAID 5, and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. G.QBOFM G.QBOFM G.QBOFM SATA2_5 7 7 SATA2_4 SATA2_3 SATA2_2 SATA2_1 SATA2_0 Pin No. Definition 1 GND 1 2 TXP 1 3 TXN 4 GND 5 RXN 6 RXP 7 GND 8) GSATA3_6/7 (SATA 6Gb/s Connectors, Controlled by Marvell 88SE9182) BUG ORT DEBUG PORT The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The Marvell 88SE9182 control- ler supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. G.QBOFM GSATA3_7 7 1 7 1 GSATA3_6 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND Please connect the L-shaped end of BUG RT the SATA cable to your SATA hard drive. • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. • A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) • A RAID 10 configuration requires four hard drives. Hardware Installation - 30 -