Gigabyte G1.Assassin Manual - Page 55

2-6 Integrated Peripherals CMOS Setup Utility-Copyright (C) 1984-2010 Award Software Integrated Peripherals eXtreme Hard Drive (XHD) ICH SATA Control Mode SATA Port0-3 Native Mode USB Controllers USB Keyboard Function USB Mouse Function USB Storage Function Onboard Audio Onboard H/W LAN Onboard USB 3.0 Controller GSATA3 6_7/IDE Controller GSATA3 6_7/IDE Ctrl Mode [Disabled] [IDE] [Disabled] [Enabled] [Enabled] [Disabled] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] [IDE] Item Help Menu Level  Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults eXtreme Hard Drive (X.H.D) (Intel ICH10R South Bridge) Enables or disables the X.H.D function for the SATA controllers integrated in the Intel ICH10R South Bridge. When set to Enabled, the ICH SATA Control Mode item below will be set to RAID(XHD) au- tomatically. For details on using the GIGABYTE X.H.D utility, refer to Chaper 4, "eXtreme Hard Drive (X.H.D)." (Default: Disabled) ICH SATA Control Mode (Intel ICH10R South Bridge) Enables or disables RAID for the SATA controllers integrated in the Intel ICH10R South Bridge or config- ures the SATA controllers to AHCI mode. IDE Disables RAID for the SATA controllers and configures the SATA controllers to IDE mode. (Default) RAID(XHD) Enables RAID for the SATA controllers. AHCI Configures the SATA controllers to AHCI mode. Advanced Host Controller Interface (AHCI) is an interface specification that allows the storage driver to enable advanced Serial ATA features such as Native Command Queuing and hot plug. SATA Port0-3 Native Mode (Intel ICH10R South Bridge) Specifies the operating mode of the integrated SATA controllers. Disabled Allows the SATA controllers to operate in Legacy IDE mode. In Legacy mode the SATA controllers use dedicated IRQs that cannot be shared with other device. Set this option to Disabled if you wish to install operating systems that do not support Native mode. (Default) Enabled Allows the SATA controllers to operate in Native IDE mode. Enable Native IDE mode if you wish to install operating systems that support Native mode. USB Controllers Enables or disables the integrated USB controller. (Default: Enabled) Disabled will turn off all of the USB functionalities below. - 55 - BIOS Setup