Gigabyte GA-6JIEV2-RH Manual - Page 14

1 ) IDE1 (IDE cable connector) Connector Introduction An IDE device connects to the computer via an IDE connector. One IDE connector can connect to one IDE cable, and the single IDE cable can then connect to two IDE devices (hard drive or optical drive). If you want to connect two IDE devices, please set the jumper on one IDE device as Master and the other as Slave (for information, please refer to the instructions located on the IDE device). Before attaching the IDE cable, please take note of the foolproof groove in IDE connector. 2 44 1 43 2/3 ) SATA 1/2 (Serial ATA cable connectors) SATA 3Gb/s can provide up to 300MB/s stransfer rate. Please refer to the BIOS setting for the SATA 3Gb/s and install the proper driver in order to work properly. 1 Pin No. Definition 1 GND 2 TXP 3 TXN 4 GND 5 RXN 7 6 RXP 7 GND 14