Haier HW50-1010 User Manual - Page 15

Error Signals The door lock light will flash in different combinations to signal when ther e is an error, see the table below for the meanings. Error message Error 1: The start indicator wasn't lighted,and the buzzer sound abnormaly. Error 2: The start indicator lighted on 0.2s and off 0.2s for twice,repeate 4s later . Cause Door not shut pr operly. Drainage error, water has not emptied within 4 minutes. Solution Shut door pr operly. Clean the filter (page 15) and check drain hose for blockages. If pr oblem continues, contact an appr oved service engineer. Error 3: The start indicator lighted on 0.2s and off 0.2s for 3 times,repeate 4s later . Temperature sensor is not properly connected or damaged. Contact an appr oved service engineer. Error 4: The start indicator lighted on 0.2s and off 0.2s for 4 times,repeate 4s later . Heating element error, set temperature is not reached within specifi ed time (this will be displayed at the end of the programme). Contact an appr oved service engineer. Error 5: The start indicator lighted on 0.2s and off 0.2s for 5 times,repeate 4s later . Correct water level not reached within 8 minutes. Ensure the tap is fully open and water pressure is normal. If problem continues, contact an appr oved service engineer. Error 6: The start indicator lighted on 0.2s and off 0.2s for 6 times,repeate 4s later . Timer error. Contact an appr oved service engineer. Error 7: The start indicator lighted on 0.2s and off 0.2s for 7 times,repeate 4s later . Motor overheating. Contact an appr oved service engineer. Error 8: The start indicator lighted on 0.2s and off 0.2s for 8 times,repeate 4s later . Water overflow. Contact an appr oved service engineer. 14