Haier HW50-1010 User Manual - Page 5

Installation Unpacking your washing machine Caution: 2 people are required to 1 unpack and handle the washing machine, it is recommended that gloves are worn. a: Carefully remove all packaging materials including the foam base, dispose of corr ectly . Note: When opened, water droplets may be visible in the drum etc. this is normal as each appliance is factory tested. b: Remove the drain hose and power cable from the clips on the back of the machine (1). Removing the packing bolts Important: The packing bolts are 2 designed to support the internal components during transit, these MUST be removed before use. a: Remove the back cover plate, by r emoving the 3 screws shown and sliding down the back cover plate (2 & 3). b: Remove all 3 packing bolts fr om the back using a 13mm spanner or large flatblade screwdriver. Remove the 3 rubber spacers from inside the back of the washing machine (4). Note: Keep the packing bolts and rubber 4 spacers in a safe place for possible later use. c: Replace the back cover plate and refit the screws. d: Push fit the plastic plugs into the holes left by the packing bolts (insert - 4). Hose/ cable clips 3 4