Haier QAS740RMSS Use and Care Manual - Page 19

Oven Light, Oven Door

Get Haier QAS740RMSS PDF manuals and user guides View all Haier QAS740RMSS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

ENGLISH CARE AND CLEANING OVEN LIGHT WARNING SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical power to the range at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn. CAUTION BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with bare hands or a damp cloth can cause burns. Oven Light Replacement Be sure to let the light cover and bulb cool completely. To remove the cover: 1. Hold a hand under the cover so it doesn't fall when released. With fingers of the same hand, firmly push back the wire cover holder. Lift off the cover. Do not remove any screws to remove the cover. 2. Replace bulb with a 40-watt appliance bulb. To replace the cover: 1. Place it into groove of the light receptacle. Pull wire forward to the center of the cover until it snaps into place. 2. Connect electrical power to the range. Wire cover holder OVEN DOOR The door is very heavy. Be careful when removing and lifting the door. Do not lift door by the handle. To Remove the Door: 1. Fully open the door. 2. Pull the hinge locks up and away from the range frame to the unlocked position. 3. Firmly grasp both sides of the door near the top. 4. Close door until the top of the door is approximately 6" from the range frame. 5. Lift door up and away from the range until both hinge arms are clear of the slots in the range frame. Pull hinge locks up to unlock Removal position To Replace the Door: 1. Firmly grasp both sides of the door near the top. 2. With the door at the same angle as the removal position, rest the notch on the underside of the left hinge arm on the bottom edge of the left hinge slot. The notch in the hinge arm must be fully seated into the bottom of the slot. Repeat for the right side. 3. Fully open the door. If the door will not fully open, the notches in the bottoms of the hinge arms have not seated correctly in the bottom edge of the slot. Lift the door off the range and repeat previous step. 4. Push the hinge locks toward the range cavity and down to the locked position. 5. Close the oven door. Bottom edge of slot Hinge arm Notch Rest notch on bottom edge of hinge slot Push hinge locks down to lock 49-88074 Rev. 2 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
49-88074
Rev. 2
19
ENGLISH
CARE AND CLEANING
OVEN LIGHT
WARNING
SHOCK OR BURN HAZARD:
Before
replacing oven light bulb, disconnect the electrical power to
the range at the main fuse or circuit breaker panel. Failure to
do so may result in electric shock or burn.
CAUTION
BURN HAZARD:
The glass cover and bulb
should be removed when cool. Touching hot glass with bare
hands or a damp cloth can cause burns.
Oven Light Replacement
Be sure to let the light cover and bulb cool completely.
To remove the cover:
1.
Hold a hand under the cover so it doesn’t fall when
released. With fingers of the same hand, firmly push
back the wire cover holder. Lift off the cover.
Do not remove any screws to remove the cover.
2.
Replace bulb with a 40-watt appliance bulb.
To replace the cover:
1.
Place it into groove of the light receptacle. Pull wire
forward to the center of the cover until it snaps into place.
2.
Connect electrical power to the range.
OVEN DOOR
The door is very heavy. Be careful when removing and lifting
the door. Do not lift door by the handle.
To Remove the Door:
1.
Fully open the door.
2.
Pull the hinge locks up and away from the range frame to
the unlocked position.
3.
Firmly grasp both sides of the door near the top.
4.
Close door until the top of the door is approximately 6”
from the range frame.
5.
Lift door up and away from the range until both hinge
arms are clear of the slots in the range frame.
To Replace the Door:
1.
Firmly grasp both sides of the door near the top.
2.
With the door at the same angle as the removal position,
rest the notch on the underside of the left hinge arm on
the bottom edge of the left hinge slot. The notch in the
hinge arm must be fully seated into the bottom of the
slot. Repeat for the right side.
3.
Fully open the door. If the door will not fully open, the
notches in the bottoms of the hinge arms have not
seated correctly in the bottom edge of the slot. Lift the
door off the range and repeat previous step.
4.
Push the hinge locks toward the range cavity and down
to the locked position.
5.
Close the oven door.
Push hinge locks down to lock
Rest notch on bottom edge
of hinge slot
Notch
Bottom
edge of
slot
Hinge arm
Removal position
Pull hinge locks up to unlock
Wire cover holder