Harman Kardon DPR 1001 Owners Manual - Page 2

DPR 1001 DIGITAL PATH RECEIVER 3 Introduction 4 Safety Information 4 Unpacking 5 Front Panel Controls 7 Front Panel Information Display 8 Rear Panel Connections 10 Main Remote Control Functions 13 Zone II Remote Control Functions 14 Installation and Connections 16 System Configuration 16 Speaker Placement 17 Speaker Optimizer 18 Input Setup 18 Surround Setup 19 Speaker Setup 21 Delay Settings 22 Output Level Adjustment 22 Using EzSet 24 Operation 24 Basic Operation 24 Remote Control Operation 24 Source Selection 25 Volume Control 25 Surround Mode Selection 25 Digital Audio Playback 26 Surround Mode Chart 28 Tuner Operation 28 Recording 29 Front Panel Connections 29 Output Level Trim Adjustment 29 6/8-Channel Direct Input 30 Advanced Features 30 Surround Back Amplifier Assignment 30 Display Brightness 30 Turn-On Volume Level 30 OSD Settings 31 Multiroom Operation 31 Multiroom Setup 32 Multiroom Operation 32 Configuring the Remote 32 Preprogrammed Code Entry 33 Automatic Code Entry 34 Learning Commands 35 Changing Devices 35 Macro Programming 37 Punch-Through Configuration 37 Volume Punch-Through 38 Channel Punch-Through 38 Transport Punch-Through 39 EzSet Configuration 39 Renaming 39 Renaming a Device 40 Renaming Individual Keys 41 Resetting the Remote 42 Troubleshooting Guide 42 Processor Reset 43 Technical Specifications 43 Trademark acknowledgements Typographical Conventions In order to help you use this manual with the remote control, front panel controls and rear panel connections, certain conventions have been used. EXAMPLE - (bold type) indicates a specific remote control or front panel button, or rear panel connection jack EXAMPLE - (OCR type) indicates a message that is visible on-screen or on the front panel information display EXAMPLE - (Synchro type) indicates a message that is displayed on the remote's LCD screen 0 - (number in a square) indicates a specific front panel control ¡ - (number in a circle) indicates a rear panel connection a - (number in an oval) indicates a button or indicator on the remote A - (letter in a square) indicates an indicator in the front panel information display å - (letter in an oval) indicates a button on the Zone II remote 2 TABLE OF CONTENTS