Hayward Pool Vac XL All Models - Page 11
Maintenance Tips - replacement shoe
View all Hayward Pool Vac XL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Pool Vac Ultra MAINTENANCE TIPS 1. CHECK THE CONDITION OF THE "SHOES, WINGS AND FLAPS" PERIODICALLY. The shoes and wings have wear indicators on their sides and should be checked occasionally to determine if they need replacing. The shoe wear indicator is a line on the side of the shoe that appears as a difference in texture. When this texture difference is no longer visible at the bottom of the shoe when viewed from either side, the shoes must be changed (see Figure 8). Also on the side, the wing wear indicator is a horizontal line which has three (3) vertical lines above it. When you can no longer see the horizontal line, the wings must be changed (see Figure 9). The Hayward Pool Vac Ultra Tune-Up Kit is available from your dealer. Shoes, wings and flaps may also be purchased separately. 2. SHOE REPLACEMENT: a) Turn unit upside down. b) Insert screwdriver between foot and shoe on one of the pods (see Figure 8). c) Using a lifting motion, remove the shoe from the foot. d) Dip a new shoe in water and attach the shoe to the foot, making sure to put the small post into the small hole and the large post into the large hole. These posts and holes are different sizes to prevent the shoes from being improperly installed. e) Repeat Steps b, c and d for each shoe. Figure 8 GOOD SHOE WEAR MARK WORN SHOE 9