Hayward TriStar® VS Owners Manual - Page 8

TriStar Variable Speed Pump Control, USE ONLY HAYWARD GENUINE REPLACEMENT PARTS, VARIABLE SPEED

Get Hayward TriStar® VS PDF manuals and user guides View all Hayward TriStar® VS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

TriStar Variable Speed Pump Control ____ Page 8 of 16 VARIABLE SPEED INTERFACE - INITIAL SETUP NOTES: 1) When power is applied to the system for the first time, or if initial setup override is engaged, the user will have to set the system language, clock, and prime mode before the pump will operate. During the initial system setup, the 1 (Exit) button is not active. The user must make these selections before the system will allow the pump to operate. If a mistake is made during the initial setup, the user may override the incorrect setup by disconnecting power to the system, and re-applying power while pressing the 4 button. The language and clock settings may be changed after initial system setup as shown in the Installer Setup chart if needed. 2) The user must select the prime mode based on the layout of their pump installation. Choose "MORE THAN 5 FT" if the inlet of the pump is more than 5 feet above the water level in the pool, or choose "5 FEET OR LESS" if the inlet of the pump is 5 feet or less above the water level in the pool. WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
TriStar Variable Speed Pump Control
____
____________________________Page 8 of 16
WWW.HAYWARDPOOL.COM
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
VARIABLE SPEED INTERFACE – INITIAL SETUP NOTES:
1
)
When power is applied to the system for the first time, or if initial setup override is engaged, the user will have to set the system
language, clock, and prime mode before the pump will operate.
During the initial system setup, the 1 (Exit) button is not active.
The
user must make these selections before the system will allow the pump to operate.
If a mistake is made during the initial setup, the
user may override the incorrect setup by disconnecting power to the system, and re-applying power while pressing the 4 button. The
language and clock settings may be changed after initial system setup as shown in the Installer Setup chart if needed.
2
)
The user must select the prime mode based on the layout of their pump installation.
Choose “MORE THAN 5 FT” if the inlet of
the pump is more than 5 feet above the water level in the pool, or choose “5 FEET OR LESS” if the inlet of the pump is 5 feet or less
above the water level in the pool.