HealthRider H70e Elliptical English Manual - Page 6

1. To make assembly easier, read the 1 information on page 5 before you begin assembling the elliptical exerciser. Identify the Front Stabilizer (8), which has Wheels (40) attached. While another person lifts the front of the Frame (1) and holds the Pedal Legs (4, 5) in the position shown, slide the Front Stabilizer (8) onto the Frame. Attach the Front Stabilizer (8) to the Frame (1) 1 with four M8 x 44mm Patch Screws (84). While another person lifts the rear of the 40 Frame (1), attach the Rear Stabilizer (not shown) to the Frame in the same way. 84 2. Have another person hold the Upright (2) near the Frame (1). See the inset drawing. Locate the wire tie in the Upright (2). Tie the lower end of the wire tie to the Wire Harness (42). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: To prevent the Wire Harness from falling inside the Upright, secure the Wire Harness with a rubber band. Tip: Avoid pinching the Wire Harness (42). Insert the Upright (2) into the Frame (1). Attach the Upright (2) with four M10 x 20mm Patch Screws (70) and four M10 Split Washers (73). Do not tighten the Patch Screws yet. 2 2 70 73 73 70 4, 5 8 84 42 Avoid pinching the Wire Harness (42) 70 73 1 Wire Tie 42 6