HP 10636 HP 10000 G2 Series Rack Options Installation Guide - Page 107
Installing the rear extension assembly
View all HP 10636 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
4. Using a T-25 Torx driver, remove the upper and lower rear door lock catches by removing the two screws from each of the upper and lower rear door lock catches. Retain the door lock catches and screws for reinstallation. Installing the rear extension assembly 1. Install the side assemblies of the rear extension assembly. a. Align the right-side assembly with the rack frame (1). b. Hook the extension into the rack frame at the three hook locations at the top, middle, and bottom of the rack. c. Using a T-25 Torx screwdriver, insert and tighten one M5.5 self-tapping screws into each of the three hook locations to secure the side assembly to the rack frame (2). d. Repeat steps a through c for the left-side assembly. 2. Install the top assembly of the rear extension assembly. Rear Extension kit 107