HP 10636 HP 10000 G2 Series Rack Options Installation Guide - Page 96
Using a T-25 Torx driver, insert and tighten two M6 machine screws into the rear screw holes 2.
![]() |
View all HP 10636 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
d. Repeat steps a through c for the left-side assembly. 2. Install the top assembly of the rear extension assembly. a. Align the top assembly with the installed side assemblies (1). b. Using a T-25 Torx driver, insert and tighten two M6 machine screws into the rear screw holes (2). c. Using a T-25 Torx driver, insert and tighten two M6 machine screws into the front screw holes (3). 3. Install the bottom assembly of the rear extension assembly. a. Align the bottom assembly with the installed side assemblies (1), making sure to set the metal tab at the front of the assembly over the rear rack frame (2). Rack Air Duct kit 96
![](/manual_guide/products/hewlettpackard-10636-hp-10000-g2-series-rack-options-installation-guide-d108d9f/96.png)
Rack Air Duct kit
96
d.
Repeat steps a through c for the left-side assembly.
2.
Install the top assembly of the rear extension assembly.
a.
Align the top assembly with the installed side assemblies (1).
b.
Using a T-25 Torx driver, insert and tighten two M6 machine screws into the rear screw holes (2).
c.
Using a T-25 Torx driver, insert and tighten two M6 machine screws into the front screw holes (3).
3.
Install the bottom assembly of the rear extension assembly.
a.
Align the bottom assembly with the installed side assemblies (1), making sure to set the metal tab at
the front of the assembly over the rear rack frame (2).