HP 14-w000 14 Notebook PC Maintenance and Service Guide - Page 72
Power connector cable, System board see
View all HP 14-w000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Power connector cable Description Power connector cable (includes bracket) Spare part number 732067-001 Before removing the power connector cable, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 25), and then remove the following components: a. Service door (see Service door on page 26) b. Optical drive (see Optical drive on page 32) c. Memory module (see Memory module on page 28) d. WLAN module (see WLAN module on page 30) e. Keyboard (see Keyboard on page 34) f. Top cover (see Top cover on page 41) g. Hard drive (see Hard drive on page 44) h. System board (see System board on page 52) Remove the power connector board: NOTE: The power connector bracket was disconnected when removing the system board. 1. Position the system board upside down with the front toward you. 2. Release the power connector from the clip built into the system board. Reverse this procedure to install the power connector cable. 62 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts