HP 260 Maintenance and Service Guide - Page 61
Computer Setup—Power, Computer Setup-Advanced for advanced users
![]() |
View all HP 260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Computer Setup-Power NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration. Table 5-4 Computer Setup-Power Option OS Power Management Hardware Power Management Thermal Description ● Runtime Power Management-Enable/Disable. Allows certain operating systems to reduce processor voltage and frequency when the current software load does not require the full capabilities of the processor. Default is enabled. ● Idle Power Savings-Extended/Normal. Allows certain operating systems to decrease the processors power consumption when the processor is idle. Default is extended. SATA Power Management - Enables or disables SATA bus and/or device power management. Default is enabled. S5 Maximum Power Savings - Turns off power to all nonessential hardware when system is off to meet EUP Lot 6 requirement of less than 0.5 Watt power usage. Default is disabled. S4/S5 Wake On LAN. Lets you set the computer to power on at the specified days/times set in the BIOS power-on. Default is disabled. Power on from USB Kbd Port. Default is disabled. CPU Fan Speed-Shows the fan speed. Computer Setup-Advanced NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration. Table 5-5 Computer Setup-Advanced (for advanced users) Option Power-On Options BIOS Power-On Onboard Devices Heading Allows you to set: ● POST messages (enable/disable). Enabling this feature will cause the system to display POST error messages, which are error messages displayed on the monitor during the Power On Self Test if the BIOS encounters some kind of problem while starting the PC. A POST error message will only display on screen if the computer is capable of booting this far. If the POST detects an error before this point, a beep code is generated instead. Default is disabled. ● After Power Loss (off/on/previous state). Default is Power off. Setting this option to: ◦ Power off-causes the computer to remain powered off when power is restored. ◦ Power on-causes the computer to power on automatically as soon as power is restored. ◦ Previous state-causes the computer to power on automatically as soon as power is restored, if it was on when power was lost. NOTE: If you turn off power to the computer using the switch on a power strip, you will not be able to use the suspend/sleep feature or the Remote Management features. ● POST Delay (in seconds). Enabling this feature will add a user-specified delay to the POST process. This delay is sometimes needed for hard disks on some PCI cards that spin up very slowly, so slowly that they are not ready to boot by the time POST is finished. The POST delay also gives you more time to select F10 to enter Computer (F10) Setup. Default is None. Allows you to set the computer to turn on automatically at a time you specify. Allows you to set resources for or disable Legacy devices. Computer Setup (F10) Utilities 53
![](/manual_guide/products/hewlettpackard-260-maintenance-service-guide-bd407ed/61.png)