HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 358

Configuring for Network Management Applications Using SNMP Tools To Manage the Switch 1. Configure users in the User Table with the snmpv3 user command. To view the list of configured users, enter the show snmpv3 user command (see "Adding Users" on page 13-10). 2. Assign users to Security Groups based on their security model with the snmpv3 group command (see "Assigning Users to Groups" on page 13-12). Caution If you add an SNMPv3 user without authentication and/or privacy to a group that requires either feature, the user will not be able to access the switch. Ensure that you add a user with the appropriate security level to an existing security group. Adding Users. To configure an SNMPv3 user, you must first add the user name to the list of known users with the snmpv3 user command. ProCurve(config)# snmpv3 user NetworkAdmin Add user Network Admin with no authentication or privacy. ProCurve(config)# snmpv3 user NetworkMgr auth md5 authpass priv privpass Add user Network Mgr with authentication and privacy. MD5 authentication is enabled and the password is set to "authpass". ProCurve(config)# show snmpv3 user Privacy is enabled and the password is set to "privpass". Status and Counters - SNMP v3 Global Configuration Information User Name initial NetworkAdmin Auth. Protocol MD5 MD5 Privacy Protocol CFB AES-128 CBC-DES Figure 13-2. Adding SNMPv3 Users and Displaying SNMPv3 Configuration 13-10