HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 396

Configuring for Network Management Applications LLDP (Link-Layer Discovery Protocol) Spanning-Tree Blocking. Spanning tree does not prevent LLDP packet transmission or receipt on STP-blocked links. 802.1X Blocking. Ports blocked by 802.1X operation do not allow transmission or receipt of LLDP packets. Configuring LLDP Operation In the default configuration, LLDP is enabled and in both transmit and receive mode on all active ports. The LLDP configuration includes global settings that apply to all active ports on the switch, and per-port settings that affect only the operation of the specified ports. The commands in this section affect both LLDP and LLDP-MED operation. for information on operation and configuration unique to LLDP-MED, refer to "LLDP-MED (Media-Endpoint-Discovery)" on page 13-62. Command show lldp config [no] lldp run lldp refresh-interval lldp holdtime-multiplier lldpTxDelay lldpReinitDelay lldp enable-notification lldpnotificationinterval lldp admin-status < txonly | rxonly | tx_rx | disable > lldp config < port-list > IpAddrEnable lldp config < port-list > basicTlvEnable lldp config < port-list > dot3TlvEnable < macphy_config > Page 13-50 13-50 13-51 13-52 13-52 13-53 13-54 13-55 13-55 13-56 13-57 13-59 Viewing the Current Configuration Displaying the Global LLDP, Port Admin, and SNMP Notification Status. This command displays the switch's general LLDP configuration status, including some per-port information affecting advertisement traffic and trap notifications. Syntax show lldp config 13-48