HP 6120XG ProCurve Series 6120 Blade Switches Management and Configuration Gui - Page 455

Note File Transfers Downloading Switch Software The Bad file number is from the system error value and may differ depending on the cause of the failure. In the third example, the device file to read was closed as the device read was about to occur. Attempt to Start a Session During a Flash Write. If you attempt to start an SCP (or SFTP) session while a flash write is in progress, the switch will not allow the SCP or SFTP session to start. Depending on the client software in use, the following error message may appear on the client console: Received disconnect from 10.0.12.31: 2: Flash access in progress lost connection Failure to Exit from a Previous Session. This next example shows the error message that may appear on the client console if a new SCP (or SFTP) session is started from a client before the previous client session has been closed (the switch requires approximately ten seconds to timeout the previous session): Received disconnect from 10.0.12.31: 2: Wait for previous session to complete lost connection Attempt to Start a Second Session. The switch supports only one SFTP session or one SCP session at a time. If a second session is initiated (for example, an SFTP session is running and then an SCP session is attempted), then the following error message may appear on the client console: Received disconnect from 10.0.12.31: 2: Other SCP/SFTP session running lost connection Using Xmodem to Download Switch Software From a PC or UNIX Workstation This procedure assumes that: ■ The switch software is stored on a disk drive in the PC. ■ The terminal emulator you are using includes the Xmodem binary transfer feature. (For example, in the HyperTerminal application included with Windows NT, you would use the Send File option in the Transfer dropdown menu.) A-19