HP 8/40 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June - Page 621
sfpShow, Displays Small Form-factor Pluggable SFP information. - specs
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 621 highlights
sfpShow 2 sfpShow Displays Small Form-factor Pluggable SFP information. Synopsis sfpshow [[slotnumber/]geportnumber | -all] Description Use this command to display information about Serial Identification SFPs (also known as module definition "4" SFPs). These SFPs provide extended information that describes the SFP's capabilities, interfaces, manufacturer, and other information. Use this command with no operand to display a summary of all SFPs in the switch. The summary displays the SFP type (refer to switchShow for an explanation of the two-letter codes) and, for serial ID SFP, the vendor name and SFP serial number. Use this command with the slotnumber and portnumber operands to display detailed information about the serial ID SFP in the specified port. In this mode, this command displays values described in the "Gigabit Interface Converter" spec by Sun Microsystems, et al. Use the -all operand to display detailed information for all available SFPs. For Finisar "smart" SFPs, five additional fields display: module temperature, voltage, received optical power, transmitted optical power (longwave only), and laser diode drive current. Notes The sfpShow command does not reflect changes in the sfpShow output if any SFPs are replaced or removed while a port or a switch is disabled. The execution of this command is subject to Admin Domain restrictions that may be in place.Refer to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability" for details. Operands This command has the following operands: slotnumber For bladed systems only, specify the slot number of the port to display, followed by a slash (/) portnumber Specify the number of the port for which to display the SFP information, relative to its slot for bladed systems. Use switchShow for a list of valid ports. This operand is optional; if omitted, this command displays a summary of all SFPs on the switch. -all Displays detailed data for all available SFPs on the switch. This operand is not compatible with slotnumber/portnumber operands. Examples To display SFP summary information: switch:admin> sfpshow Area 0: id (id) Vendor: Serial No: Area 1: id (sw) Vendor: FINISAR CORP. Area 2: id (sw) Vendor: FINISAR CORP. Area 3: id (sw) Vendor: FINISAR CORP. Area 4: id (sw) Vendor: IBM Area 5: id (sw) Vendor: IBM Area 6: id (sw) Vendor: IBM Area 7: id (sw) Vendor: IBM Area 8: -Area 9: -Area 10: -Area 11: -- Serial No: H1149T2 Serial No: H112TUD Serial No: H11QET9 Serial No: 21P53380BR0BE Serial No: 21P53380BS18A Serial No: 21P53380BS170 Serial No: 21P53380BS26B Fabric OS Command Reference 595 53-1000599-02