HP 8/40 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June - Page 87
cfgEnable, command for a description of defined and effective
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
cfgEnable 2 cfgEnable Enables a zone configuration. Synopsis cfgenable "cfgName" Description Use this command to enable a zone configuration. The command builds the specified zone configuration by checking for undefined zone names, zone alias names, or other inconsistencies, by expanding zone aliases, removing duplicate entries, and then installing the effective configuration. If the build fails, the previous state is preserved (zoning remains disabled, or the previous effective configuration remains in effect). If the build succeeds, the new configuration replaces the previous configuration. Refer to the cfgShow command for a description of defined and effective configurations. Note When FCS policy is enabled, this command can be issued only from the primary FCS switch. Operands The following operand is required: "cfgName" Specifies the name of the zone configuration. The name must be enclosed in quotation marks. Examples To enable the zone configuration "USA_cfg": switch:admin> cfgenable "USA_cfg" You are about to enable a new zoning configuration. This action will replace the old zoning configuration with the current configuration selected. Do you want to enable 'USA_cfg' configuration (yes, y, no, n): [no] y zone config "USA_cfg" is in effect Updating flash ... See Also cfgClear, cfgDisable, cfgSave, cfgShow Fabric OS Command Reference 61 53-1000599-02