HP AM866A Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01, July 2009 - Page 609
The default value is 0. A low value encourages the use of the, route
UPC - 884420064602
View all HP AM866A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 609 highlights
portCfg 2 portcfg iproute [slot/][ge]port option arguments Valid options and arguments for iproute are: create dest_ipaddr [gateway_router] metric Creates an IP route. Specify the following dest_ipaddr Specifies the destination IP address in either IPv6 or IPv4 format: dest_IPv6_addr/prefix_len Specifies the destination IPv6 address of the virtual port, if IPv6 is used. The address must be an IPv6 global, unicast address, followed by a prefix. This is used for IPv6 addresses instead of a netmask. The prefix_len operand is required. dest_IPv4_addr netmask Specifies the destination IPv4 address of the virtual port, if IPv4 is used. If an IPv4 address is used, the subnet mask must be specified as well. Use a.b.c.d. format. gateway_router Specifies the IP address of an IP router that can route packets to the destination virtual port IP address. The gateway address must be on the same IP subnet as one of the port IP addresses. This operand is optional with IPv6 addresses. If not specified, the gateway_router learned from the Neighbor Discovery protocol is used. metric Specifies the link metric associated with the route. Valid values are 0-255. The default value is 0. A low value encourages the use of the route, and a high value discourages the use of the route. This operand is valid only on the Brocade 7500/7500E/FR4-18i platforms. delete ipaddr ipaddr This operand is not valid on the Brocade 7800 and FX8-24. Deletes IP routes for a specified IPv4 or IPv6 address. Specifies IP address in either IPv6 or IPv4 format: IPv6_addr/prefix_len Specifies the IPv6 address of the virtual port, if IPv6 is used. The address must be an IPv6 global, unicast address, followed by a prefix. The prefix_len operand is required. dest_IPv4_addr netmask Specifies the destination IPv4 address of the virtual port, if IPv4 is used. If an IPv4 address is used, the subnet mask must be specified as well. Use a.b.c.d. format. Examples To create an IP interface using IPv4: switch:admin> portcfg ipif 4/ge0 create 11.81.0.110. 255.0.0.0 1500 Operation Succeeded switch:admin> portshow ipif 4/ge0 Port: ge0 Interface IP Address NetMask MTU 0 11.81.0.110 255.0.0.0 1500 Fabric OS Command Reference 579 53-1001337-01