HP AM866A Brocade Fabric OS Command Reference v6.3.0 (53-1001337-01, July 2009 - Page 617
Con the FC port for FC Fastwrite., Manage VLAN Tagging configuration for FCIP.
UPC - 884420064602
View all HP AM866A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 617 highlights
portCfg 2 Path MTU Disc: 0 VLAN ID: 0 L2CoS: F: 0 H: 0 M: 0 L: 0 DSCP: F: 0 H: 0 M: 0 L: 0 Flags: 0x00000000 To set the compression rate to 'moderate' on the tunnel: switch:admin> portcfg fciptunnel 1/12 modify -c 2 Operation succeeded To enable and configure FICON emulation on the tunnel: switch:admin>portcfg fciptunnel 1/12 modify -F 1 --ficon xrc 1 Operation succeeded To configure FastWrite and Tape Pipelining on the tunnel: switch:admin>portcfg fciptunnel 1/12 modify -f 1 -t 1 Operation succeeded To delete circuit 1: switch:admin>portcfg fcipcircuit 1/12 delete 1 Operation succeeded Function Synopsis Commands supported only on the Brocade 7500/7500E and the Brocade FR4-18i platforms portcfg action [slot/] ge_port arguments Description Use this command to manage configuration parameters for ports and Gigabit Ethernet (GbE) ports on the Brocade 7500 and 7500E FC Router switches and on the FR4-18i FC Router blade. The following commands are exclusive to these platforms. • portcfg arp - Add and delete address resolution protocol (ARP) entries. Flush ARP table. • portcfg fciptunnel - Create, modify, and delete Fibre Channel over IP (FCIP) tunnels. - Delete, reset, and modify QoS mappings on an existing tunnel. - Create or modify a tunnel with VLAN tagging and Class of Service (CoS). - Create or modify a tunnel with Tape read/write Pipelining enabled or disabled. - Create or modify a tunnel with Byte Streaming enabled or disabled. • portcfg mirrorport - Configure a mirror port on the local port. • portcfg rscnsuppr - Manage registered state change notification (RSCN) suppression on the local port. • portcfg faswrite - Configure the FC port for FC Fastwrite. • portcfg ficon - Manage FICON emulation in an FCIP tunnel. • portcfg vlantag - Manage VLAN Tagging configuration for FCIP. Operands This command supports the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). Fabric OS Command Reference 587 53-1001337-01